In order to evaluate and compare the efficacy of OXIFORT vs hydrogen peroxide (H2O2), commonly known as hydrogen peroxide, we have conducted a trial with the Department of Chemistry and Soil Science at the Polytechnic University of Valencia (UPV). The results showed that to try to match the effect obtained with OXIFORT in the release of oxygen, the concentration of oxygen would have to be increased up to 25 times. H2O2But could these concentrations of hydrogen peroxide have adverse effects on plants?
OXIFORT is a nitrogen fertilizer enriched with oxygen, presented as a fine, water-soluble granule that slowly releases oxygen. This oxygenates the soil or substrate, preventing root asphyxiation.
Hydrogen peroxide is frequently used in agriculture, due to its low cost, for the same purpose as OXIFORT. However, this practice is of dubious effectiveness. Therefore, CULTIFORT, in collaboration with the Department of Chemistry and Soil Science at the University of the Basque Country (UPV), conducted a trial to compare the oxygen-producing capacity of OXIFORT in aqueous solution versus hydrogen peroxide.

OXIFORT in 5 kg format
EXPERIMENTAL PROCEDURE
The test was carried out in a laboratory on a small scale, but comparable to reality. Three solutions were prepared with the concentrations of hydrogen peroxide and OXIFORT commonly used to combat root asphyxia, leaving a fourth solution as a control, containing only water. The concentrations were: 3 mg/L of hydrogen peroxide; 6 mg/L; and 200 mg/L of OXIFORT.
All of them were diluted to 100 ml with water, and the dissolved oxygen concentrations in the different solutions were then measured using an oximeter (Figure 1). Readings were taken at the same time over a period of 5 days.
Over the course of 5 days, it was observed that the concentration values of the solution with 6 mg/l of H2O2 did not vary significantly over time. Therefore, it was decided to increase the concentration to 150 mg/l to try to match the effects of the OXIFORT concentrations. However, this increase represents a 25-fold increase in the hydrogen peroxide concentration compared to the values typically used.

Figure 1. Dissolved O2 measurements with the oximeter by the Department of Chemistry and Soil Science of the Polytechnic University of Valencia.
RESULTS
The dissolved oxygen values provided by OXIFORT were initially within the normal range for irrigation water (starting at 5 mg/L). However, on the second day of the test, dissolved oxygen concentrations rose rapidly, remaining above normal levels for four days. These characteristics were observed at both concentrations, with the 4 mg/L concentration showing the highest values, reaching its peak on the third day of the test (Figure 240).
CONCLUSIONS OF THE ESSAY
- The reaction between H2O and 6 mg/l H2O2 is immediate, and its effects cease within a few hours. To try to equal the oxygen concentrations that H2O2 should release with respect to Oxifort, the concentration should be increased to around 150 mg/l of hydrogen peroxide.
- The effects of the different solutions analyzed with OXIFORT are more significant, providing a greater amount of oxygen in the water. The H2O + OXIFORT reaction is progressive and lasts approximately 4 days, reaching its peak value on the second or third day. On the fifth day, it stabilizes, reaching its initial value.
The results show that to try to match the effect obtained with OXIFORT on oxygen release, the concentration of H2O2 should be increased up to 25 times.

Figure 2. Evolution of the oxygen concentration of the different solutions.